Code E7

Code E7 - Pressure sensor problem

This code indicates that there is an error with the pressure sensor. 

The following should help:

• Make sure the tap unit is pushed fully down onto the keg (you should hear two clicks)
• Check the top of the keg for any issues with the seal
• Check the tap unit for any issues with the seal, wet the seal before attaching to the keg
• Try another keg

If the above doesn't help, please perform a hard reset:

1. Open the appliance and remove the keg.
2. Disconnect the keg from the tap unit
3. Turn off the appliance by disconnecting the power, then plug it back in.
4. Re-connect the keg and put it back into the machine
5. Leave the keg inside the powered appliance for 12 - 16 hours to cool down.

If none of this helps, please get in touch with Customer Services.